Tantalum & Polymer Capacitors
Solid tantalum and polymer capacitors for rails where volumetric density and stability both matter.
Density without the electrolyte drying out
Tantalum capacitors pack a lot of capacitance into a small case and hold it over temperature, which is why they persist on industrial boards where aluminium electrolytics would dry out or fail to fit.
The trade-off is well known: a tantalum can fail short, and inrush current is what usually kills it. Polymer parts remove most of that risk at a higher price, and are the better choice for low-ESR rails and high ripple current.
We can supply solid tantalum in the standard case sizes, polymer tantalum for switching rails, and the derating guidance that goes with them: 50% voltage derating for solid tantalum, 80% for polymer, plus a series resistor where inrush is uncontrolled.
Typical specifications
| Parameter | Sourcing range |
|---|---|
| Types | Solid tantalum, polymer tantalum, polymer aluminium |
| Capacitance | 0.1 µF – 1000 µF |
| Voltage | 4 V – 50 V |
| ESR | From 10 mΩ (polymer) |
| Case sizes | A / B / C / D / E, moulded SMD |
| Polarity | Polarised — reverse voltage not permitted |
Where it is used
FAQ
Solid tantalum or polymer?
Polymer for low-ESR switching rails and anything with high inrush. Solid tantalum where cost matters and ripple is modest, provided the 50% derating rule is respected.
Why do tantalum capacitors fail short?
The dielectric is thin and the failure mode is thermal runaway once a defect forms. Current limiting, either by design or by a series resistor, is what prevents it.
What derating do you recommend?
50% of rated voltage for solid tantalum, 80% for polymer, and a check on surge current at power-up.
Ready to Source Components?
Contact us today for competitive pricing and fast delivery worldwide.