Power Inductors & TLVR

Shielded SMD power inductors for DC-DC conversion, plus TLVR parts for high-current CPU and GPU rails.

The inductor sets the converter, not the other way round

In a switching converter the inductor defines the ripple current, the transient response and a good part of the thermal budget. Saturation current at temperature is the number that matters; the rated current on the first page is usually a thermal figure, not a magnetic one.

We can supply shielded SMD inductors from 0.1 µH to 1 mH for general DC-DC work, low-profile parts for height-constrained boards, and TLVR (trans-inductor voltage regulator) components for multi-phase supplies where transient response is the binding requirement.

For a new design, send the switching frequency, the output current and the transient you need to meet. We will propose a part with enough saturation margin at the maximum ambient, not just enough inductance.

Typical specifications

Parameter Sourcing range
Inductance 0.1 µH – 1 mH
Saturation current Up to 100 A (TLVR / moulded types)
DCR From 0.5 mΩ
Shielding Shielded, low radiation
Typical package 0402 – 1770, moulded SMD, through-hole toroid
Special types TLVR, coupled inductor, common-mode choke
Sourcing note · Availability, lead time and price are confirmed per line item when we quote — this page describes the range we can source, not stock on the shelf.

Where it is used

Buck converter output filters
Multiphase CPU and GPU power stages
Motor drive auxiliary supplies
EMI filtering in DC input paths

FAQ

What is TLVR and when is it needed?

Trans-inductor voltage regulator: coupled inductors that let a multiphase supply respond faster than its switching frequency would suggest. It matters when load steps are large and the output capacitance budget is tight — high-current processor rails, mainly.

Why does the inductor get hot at rated current?

Core loss plus DCR loss. Rated current is usually a thermal limit at a specified temperature rise, so a part running at that current in a hot enclosure will exceed it.

Do you supply low-profile parts under 2 mm?

Yes, down to about 1 mm for the smaller case sizes. Confirm the saturation current at your ambient before choosing by height alone.

Ready to Source Components?

Contact us today for competitive pricing and fast delivery worldwide.