Heatsinks & Thermal Interface Materials
Extruded and machined heatsinks, thermal pads and gap fillers quoted against a measured or estimated power loss.
Thermal parts are chosen by watts and by mounting pressure
A heatsink quote needs two numbers that are often missing: the power that has to leave the device, and the pressure the mounting method can apply. A gap filler with excellent conductivity performs worse than a thin pad if the mounting cannot compress it, and a large heatsink does nothing if the interface to the case is a dry joint.
We quote extruded profiles for volume and machined parts for prototypes, with the thermal interface material chosen against the gap tolerance of your assembly rather than against its headline conductivity. Where the mechanical design is still open, we will say which of gap, pressure or material should change first.
For boards with several heat sources we quote the thermal path per device: interface, spreader, sink and the airflow or conduction path out. Quoting only the sink is how a design ends up with a component that is cool in the lab and hot in a sealed enclosure.
Typical specifications
| Parameter | Sourcing range |
|---|---|
| Heatsink type | Extruded profile, machined, bonded fin |
| Material | AL6063 / AL6061, copper on request |
| Thermal pad | Silicone or non-silicone, 0.5 – 5 mm gap |
| Thermal conductivity | Material dependent, quoted against the gap |
| Mounting | Screw, clip, adhesive, spring |
| Finishing | Mill finish, anodised, black coated |
Where it is used
FAQ
What do you need to quote a heatsink?
Dissipated power, ambient temperature, available space and mounting method. Without the power figure any recommendation is a guess, however good the profile.
Pad or gap filler?
Pad for a defined, small gap with reasonable pressure; gap filler when the gap varies or pressure is low. The decision is mechanical before it is thermal.
Can you quote a machined prototype?
Yes, and it is usually cheaper than tooling an extrusion for a first article. Once the shape is fixed, the extrusion tool is amortised over the production quantity.
Ready to Source Components?
Contact us today for competitive pricing and fast delivery worldwide.