Copper-Clad Laminate & Aluminium Substrates

CCL, prepreg and aluminium substrates for in-house fabrication and for boards with thermal or high-frequency demands.

The material decision that is hard to reverse

Laminate choice fixes more of a board than most designers expect: dielectric constant sets impedance, Tg sets how many reflow cycles the board survives, and thermal conductivity sets how much heat can leave through the dielectric instead of through vias. Changing laminate late means re-quoting impedance and often re-qualifying the assembly process.

We supply FR-4 in the common Tg grades, prepreg matched to the core, and aluminium or metal-core substrate for LED and power boards where heat has to leave through the board. For high-frequency work we quote the laminate family that matches your loss target rather than the cheapest material with a similar Dk.

Sheet size, copper weight and thickness tolerance are the three items to state. For in-house fabrication we also confirm the prepreg resin content and gel time, because a layup that works with one batch of prepreg can delaminate with the next.

Typical specifications

Parameter Sourcing range
Material FR-4 (TG150 / TG170), aluminium substrate, metal-core
Copper weight 1 / 2 oz, 1 oz, 2 oz
Standard thickness 0.8 / 1.0 / 1.2 / 1.6 / 2.0 mm
Sheet size Standard panel, cut to size on request
Prepreg Matched resin content and gel time to the core
Thermal conductivity Standard FR-4 to high-conductivity metal-core
Sourcing note · Material supply quoted per sheet size and grade. Availability of a specific grade is confirmed at quotation.

Where it is used

In-house PCB fabrication and layup
LED lighting and driver boards
Power boards where heat leaves through the substrate
High-frequency boards with a defined loss target

FAQ

Can you supply cut-to-size sheets?

Yes, quoted per size and quantity. Cut sheets reduce waste for small in-house runs but add a cutting charge, so the crossover point is worth calculating before ordering.

Which Tg should I specify?

TG150 for most industrial boards, TG170 when the assembly sees multiple reflow cycles or the board runs hot. Higher Tg costs more and is not automatically better for a board that only sees one reflow.

Do you supply prepreg separately from the core?

Yes, and matched to the core batch where possible. Mismatched prepreg is a common cause of delamination after thermal cycling.

Is aluminium substrate the same as metal-core?

No. Aluminium substrate uses a thin dielectric on an aluminium base; metal-core can use copper or other metals with thicker dielectric. The distinction matters for isolation voltage and for how much heat can pass.

Ready to Source Components?

Contact us today for competitive pricing and fast delivery worldwide.