MOSFETs — N-Channel & P-Channel

Low-voltage and high-voltage MOSFETs for motor drives, synchronous rectification and load switching.

The switching device behind every servo axis

In a servo drive the MOSFET choice sets the switching loss, the dead time and, ultimately, how much heat the enclosure has to remove. Rds(on) alone is a poor guide: gate charge, output capacitance and the body diode recovery behaviour all matter once the bridge is switching at 20 kHz or more.

We can supply N-channel parts from 30 V to 650 V for motor bridges and synchronous rectification, P-channel parts for reverse-polarity and load switching, and logic-level variants for 3.3 V and 5 V gate drive.

For a new bridge design, send the bus voltage, continuous and peak current, switching frequency and the gate driver you intend to use. We will propose devices that match the driver rather than the lowest on-resistance in the catalogue.

Typical specifications

Parameter Sourcing range
Vds range 30 V – 650 V
Rds(on) From 1.2 mΩ
Current 1 A – 300 A (package limited)
Gate charge From 4 nC (logic level)
Typical package SOT-23, DFN 3×3 / 5×6, TO-220, TO-247, D2PAK
Common uses Motor bridge, sync rectification, hot-swap, load switch
Sourcing note · Availability, lead time and price are confirmed per line item when we quote — this page describes the range we can source, not stock on the shelf.

Where it is used

Servo and BLDC motor drives
Synchronous rectification in DC-DC
Battery protection and load switching
Inverter and power stage modules

FAQ

How do I choose between 40 V and 100 V MOSFETs for a 48 V bus?

Leave margin for regeneration and ringing. A 48 V bus routinely sees 60 V or more during braking, so 100 V parts are common unless the drive clamps the bus actively.

Do you supply matched pairs for half-bridge designs?

Yes. Send the target Rds(on) and package, and we will confirm whether the N- and P-channel parts share a thermal and switching profile that suits the bridge.

Can you supply logic-level parts for 3.3 V gate drive?

Yes. Logic-level and trench parts rated for 2.5 V to 4.5 V gate drive are available in the low-voltage range.

Are the parts original or refinished?

Original. We do not supply re-marked or refurbished MOSFETs, because the failure mode is thermal and it shows up at the customer, not at incoming inspection.

Ready to Source Components?

Contact us today for competitive pricing and fast delivery worldwide.