Operational Amplifiers & Comparators

Precision, low-noise and high-speed amplifiers, plus the comparators used for threshold and protection logic.

Amplifiers chosen by the error budget, not the datasheet headline

The right op-amp depends on which error dominates in your loop: offset drift, input bias current, voltage noise at the source impedance you actually have, or slew rate at the signal frequency you actually run. Two parts with similar headline specifications can behave very differently in a 100 kΩ bridge circuit.

We keep precision parts for instrumentation and current sensing, low-noise parts for audio and ADC drivers, and high-speed parts for encoder and pulse processing. Comparators are stocked separately, including the low-power and push-pull variants used in protection logic.

If a design is being re-spun because a part went obsolete, send the original number and the circuit function. Pin-compatible alternates exist for most dual and quad packages, but the compensation and input bias behaviour need checking.

Typical specifications

Parameter Sourcing range
Channels 1 / 2 / 4
Offset voltage From 5 µV (precision)
Input bias current From 1 pA (CMOS / JFET)
Gain bandwidth 1 MHz – 200 MHz
Supply range 1.8 – 36 V
Typical package SOT-23-5, SOIC-8, MSOP-8, TSSOP-14
Sourcing note · Availability, lead time and price are confirmed per line item when we quote — this page describes the range we can source, not stock on the shelf.

Where it is used

Current and voltage sensing
Sensor signal conditioning
ADC drivers and anti-alias filters
Comparator-based protection circuits

FAQ

Can you help select an amplifier for a shunt-based current measurement?

Yes. Send the shunt value, the current range and the ADC input range. Common-mode range and offset drift usually decide the part before bandwidth does.

Can you supply both precision and high-speed parts?

Yes, they are separate lines. Precision parts cover instrumentation and sensing; high-speed parts cover encoder, pulse and video-band signals.

Are single, dual and quad versions available in the same family?

Usually. Package and channel count can be matched within a family, which helps when one board needs both a buffer and a gain stage.

Ready to Source Components?

Contact us today for competitive pricing and fast delivery worldwide.