LDO — Low Dropout Regulators
Low-noise linear regulators for analog rails, sensor supplies and post-regulation after a switching stage.
LDOs where switching noise would cost more than the efficiency
An LDO is still the right answer whenever a rail feeds an ADC reference, a precision op-amp, a PLL or a low-level sensor. The efficiency argument only wins when the load is heavy; below a few hundred milliamps, noise and simplicity usually matter more than the dropout.
Our range covers high-PSRR low-noise parts for signal chain rails, wide-input LDOs for 12 V and 24 V industrial buses, and ultra-low quiescent current parts for battery-backed standby domains.
The parameters that decide the part are rarely the headline ones: PSRR at the switching frequency of the upstream converter, output noise in µVrms over the band the signal cares about, and thermal behaviour in the package you can actually place.
Typical specifications
| Parameter | Sourcing range |
|---|---|
| Input voltage | 1.7 – 36 V |
| Output current | 100 mA – 3 A |
| Dropout | From 90 mV at light load |
| Noise | From 6 µVrms (10 Hz – 100 kHz) |
| PSRR | Up to 80 dB at 1 kHz |
| Typical package | SOT-23-5, DFN 2×2, SOT-223, TO-252 |
Where it is used
More in this cluster
FAQ
Do you carry both low-noise and wide-input LDOs?
Yes, and they are usually different parts. Low-noise parts serve signal chain rails; wide-input parts serve 12 V and 24 V industrial buses where the dropout matters more than the noise floor.
Can you match an LDO by package when the original is obsolete?
In most cases. Package, pin-out and fixed output voltage are the three constraints we check first, followed by the input range and quiescent current.
Are fixed and adjustable versions both available?
Yes. Fixed variants are more common in production, adjustable parts in prototyping and instrumentation.
Ready to Source Components?
Contact us today for competitive pricing and fast delivery worldwide.